Hans Grohe Talis Series Instructions For Use/assembly Instructions

Also see for Talis 32440000: Instructions for use/assembly instructions

Contents

installation instructions

Hans Grohe Talis Series Instructions For Use/assembly Instructions Manual pdf 4 page image

Assembly see page 31EnglishSafety NotesGloves should be worn during installation to preventcrushing and cutting injuries.The shower system may only be used for bathing,hygienic and body cleaning purposes.The hot and cold supplies must be of equal pressures.Installation Instructions• Prior to installation, inspect the product for transport dam-ages. After it has been installed, no transport or surfacedamage will be honoured.• The pipes and the fixture must be installed, flushed andtested as per the applicable standards.• The plumbing codes applicable in the respective coun-tries must be oberserved.Technical DataOperating pressure: max. 1 MPaRecommended operating pressure: 0,1 - 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 80°CRecommended hot water temp.: 65°CThermal disinfection: max. 70°C / 4 minSafety against backflowThe product is exclusively designed for drinking water!Hansgrohe mixers can be used together with hydraulicallyand thermically controlled continuous flow heaters if theflow pressure is at least 0,15 MPa.Fault Cause RemedyInsufficient water - check valve hasn't moved back - Exchange check valves- Shower filter seal dirty - Clean filter seal between shower andhoseMixer stiff - Cartridge defective, calcified - Exchange cartridgeMixer dripping - Cartridge defective - Exchange cartridgeHot water temperature too low - Hot water limiter incorrectly set - Set hot water limiterInstantaneous heater didn’t work - Flow limiter in handshower isn’t re-moved- Remove flow limiter- Shower filter seal dirty - Clean filter seal between shower andhose- check valve hasn't moved back - Exchange check valvesSymbol descriptionDo not use silicone containing acetic acid!Adjustment (see page 33)To adjust the hot water limiter. Using a hotwater limiter in combination with a continuousflow water heater is not recommended.Test certificate (see page 40)Maintenance (see page 40)The check valves must be checked regularlyaccording to DIN EN 1717 in accordancewith national or regional regulations (at leastonce a year).Cleaningsee enclosed brochure.Dimensions (see page 36)Flow diagram(see page 38)Operation (see page 39)Spare parts(see page 34)4