Hans Grohe Metris Instructions For Use/assembly Instructions

Also see for Talis E2: Assembly instructions Instructions for use/assembly instructions Instructions for use/assembly instructions Instructions for use/assembly instructions Assembly and use instructions

Contents

installation instructions

Hans Grohe Metris Instructions For Use/assembly Instructions Manual pdf 4 page image

Assembly see page 31Safety NotesGloves should be worn during installation to preventcrushing and cutting injuries.The shower system may only be used for bathing,hygienic and body cleansing purposes.The hot and cold supplies must be of equalpressures.Installation InstructionsThe fitting must be installed, flushed and tested afterthe valid norms.Hansgrohe mixers can be used together withhydraulically and thermically controlled continuousflow heaters if the flow pressure is at least 0,15 MPa.Technical DataOperating pressure: max. 1 MPaRecommended operating pressure: 0,1 – 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 80°CRecommended hot water temp.: 65°Canti-pollution function••EnglishSymbol descriptionMaintenance (see page 36)14466XXX / 14146XXX / 15447XXX /31466000 / 31487000 / 31646000 /31946000 / 32477000 / 31486XXX: Thesafety device must be checked regularlyaccording to DIN EN 1717 in accordancewith national or regional regulations (at leastonce a year).Fault Cause RemedyMixer stiff - Cartridge defective, calcified - Exchange cartridgeMixer dripping - Cartridge defective, sedimentation - Exchange cartridgeDiverter not operating - Residue - Clean converter / grease O-rings- Water pressure to low - Increase water pressure- Diverter defective - Exchange diverterHot water temperature too low, nocold water. Instantaneous waterheater starts up when cold water isselected.- Hot water limiter incorrectly set - Set hot water limiter- Crossflow - Exchange cartridgeDo not use silicone containing acetic acid!To adjust the hot water limiter on single levermixers, please see page 33. No adjustmentis necessary when using a continuous flowwater heater.Dimensions (see page 34)Flow diagram(see page 32) Shower outlet Tub outletOperation (see page 35)Test certificate (see page 40)Spare parts (see page 38)CleaningCleaning recommendations, see enclosedbrochure.4