Hans Grohe Metris C 31073XX1 Installation Instructions Manual

Contents

install the pop-up drain

Hans Grohe Metris C 31073XX1 Installation Instructions Manual Manual pdf 12 page image

1EnglishInstall the pop-up drainRemove the plunger.Unscrew the drain outlet flange from the tee.Unscrew the tailpiece from the tee.Wrap the threads with Teflon tape. Install thetailpiece on the tee.Install the sealing gasket on the flange.Rest the flange in the sink outlet.Install the mack gasket, friction ring, retainernut, tee, and tailpiece on the flange.Tighten the retainer nut.Place the plunger in the drain.Install the two pivot ball seals on the ball rod.Install the ball rod on the tee. The end of therod must go through the loop in the bottom ofthe plunger.Tighten the pivot ball nut.Slide the link over end of pull rod. Tighten thescrew.Test the drain. Reposition the link on the ballrod if necessary.When satisfied, install the spring clip onthe ball rod.