Hanna Instruments HI 2300 Instruction Manual

Also see for HI 2300: Instruction manual

Contents

Hanna Instruments HI 2300 Instruction Manual Manual pdf 17 page image

17If RANGE is pressed when the last parameter is displayed, the meter returnsto measurement mode.Notes:ï To exit GLP mode at any time press ALT+GLP keys.ï If the calibration procedure was never performed, after displaying theID code the LCD will show the ìno CALî message blinking. Press RANGEor ALT+GLP keys to return to measurement mode.ï Last calibration data is available for EC and NaCl only. No calibrationdata can be recalled for TDS. If the meter is in TDS mode, by pressingALT+GLP keys it is possible only to view the ID code. Press ALT+GLPkeys again to return to measurement mode.ï The meter has an internal lithium battery that allows to correctlyupdate the date and time even if the power supply is disconnected.DATA TRANSFER TO PCConnect the meter to a PC through the RS232 output. Use HI 920010 (9 to9-pin) connection cable.The meter must be in measurement mode to communicate.The meter port is optoisolated and transmits data with a Baud rate of2400 bps.The user can retrieve the GLP data, request meterís parameters and thecurrent reading (current range only) from the PC directly. It is also possible tosend a command from the PC to change ranges.To communicate with the PC use the optional HI 92000 communicationsoftware. The software is provided with an exclusive on-line guide of all thecommands available and allows data printing, plotting and exporting.CHI2300Microprocessor Conductivity MeterALT FunctionsFunctionsTCATCALTLOCKSETUPGLPRANGECFMCALCALTDisplay TC FactorTCView CalibrationDataGLPSETUP Enter Setup ModeStart TemperatureCalibrationCALTTemperatureCompensationATCConfirm ValueCFMChange Value/Lock Current RangeLOCKStart CalibrationCALSelect MeasurementRangeRANGE

/ 20

Related manuals for Hanna Instruments HI 2300