Hang ups Contour L3 Assembly Instructions Manual

Contents

Hang ups Contour L3 Assembly Instructions Manual Manual pdf 16 page image

Changing the Rotation Adjustment Setting• Loosen the De-Rattler Knob.• Shorten the Main Shaft and rotate the Table Bed opposite from use into its storage position.Leave the A-Frame open and locked at the spreader arms (Figure 23).• The Pinlock Knobs serve two functions:- As a “de-rattler” to prevent excess movement of the support arms (Figure 24A)- As a “spring-loaded pinlock” to engage the Rotation Adjustment Setting (Figure 24B).• First, loosen the “de-rattler” function of the Pinlock Knobs by rotating them counterclockwise.Then pull the knobs up to disengage the pin and rotate again counterclockwise to lock themin the “out” position.• Move the Support Housing along the Rotation Adjustment Arms to the desired setting usingthe line markings as a guide. Rotate the pin clockwise to release the lock and allow the pin toengage a hole. You will hear a click when the pin is properly engaged.NOTE: Engage the Pinlock Knobs in the same setting for each of the RotationAdjustment Arms.• Turn the Pinlock Knobs clockwise again to re-engage the De-Rattler.• Rotate the Table Bed back to its use position and extend the Main Shaft to yourpreferred setting.AdjustmentsOption: instead of rotating to lockpins in the “out” position, simplypull the knobs up, slide, andrelease into your desired setting.Counterclockwise to Lock,Clockwise to Release.Counterclockwise to Loosen,Clockwise to Tighten.FIGURE 23FIGURE 24AFIGURE 24B