Hand Held Products IT4410 User Manual

Hand Held Products IT4410 User Manual Manual pdf 7 page image

1 - 32D PQA ReportingFull ReportHHP's 2D PQA reporting can be enabled in two different modes: Full Report orScreening.If you are using Quick*View, you can enable Full Report, a listing of all of a sym-bol's identifying information, measurements, and corresponding grades, by typ-ing the following menu command:2D_PQA1or by scanning the following bar code:Note: With the IT4600/4800/4X80, the PQA report is sent out as a second data/beep sequence after the bar code data. The report has its own HHP codeID of >(0X3E) so it can be uniquely identified.Screening ReportScreening is a grade-based mode that allows display of a limited list of identify-ing information, as well as only those measurements that are below MinimumAcceptable Grade (MAG) level. With the IT4600/4800/4X80, if all of the param-eters are met in the screening mode, only the bar code data will be output with abeep. If one or more of the measured parameters fail to meet the MAG, thePQA message is also sent with a beep.Note: With the IT4410/4710, screening mode outputs are also accompanied bya single beep if all parameters are okay or a triple beep if one or more ofthe measured parameters fail to meet the MAG.If you are using Quick*View, you can enable Screening by typing the followingmenu commands:2D_PQA2 when A is the Minimum Acceptable Grade2D_PQA3 when B is the Minimum Acceptable Grade2D_PQA4 when C is the Minimum Acceptable Grade2D_PQA5 when D is the Minimum Acceptable GradeFull Report