Menu
Hammerhead Rave 150 HH150 Operator's Manual
                        | |
13Service InstructionsENGINE LUBRICATION Ensure that you follow the procedures outlined in the engine owner's manual that isprovided as a supplement to this manual. Failure to follow procedures could reduce the life of your engine.VEHICLE LUBRICATION - Every two or three hours of use lubricate the following items with several drops ofoil; steering bearing points, brake rod pivot points, pedal pivot points, steering spindles, and steering rod ends.Use the same grade of lubricating oil that is used in the engine crankcase.CHAIN LUBRICATION - For the best chain life, it should be lubricated with a graphite type lubricant such asthe spray-on type which evaporates leaving the graphite on the chain. Using oil or grease on the chain industy or sandy riding conditions may cause dirt particles to stick to the chain resulting in rapid wear fromabrasion.FRONT WHEEL REPLACEMENT - Care must be used when replacing wheels. DO NOT OVER-TIGHTENAXLE NUTS. It is only necessary to tighten the nuts so that the wheel turns freely on the axle with minimumend play. If the wheel does not turn freely the nut is too tight.REAR WHEEL REPLACEMENT - Loosen the large locknut in the center of the wheel to remove the rearwheel.CHAIN ADJUSTMENT - After the first two hours of operation, check the chain adjustment and readjust it if ithas more than 3/8" flex. Loosen the engine clamp nuts and slide the engine and jack shaft assemblyrearward to tighten the chain. Allow about 3/8" flex for proper adjustment. Tighten the nuts securely. Onmodels equipped with a centrifugal clutch, the engine may need to be moved forward to tighten the chain. |
Related manuals for Hammerhead Rave 150 HH150
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved