Menu
Halo home Smart MicroEdge HLB QL6 Installation Instructions Manual
            |
B. Bluetooth Module• Safety Glasses• Gloves• Hole/Drywall Saw• Wire Strippers• Flathead Screwdriver• Drill• Screws for mounting (if required bylocal code• New Construction Mounting Frames(4”: HL4RSMF; 6”: HL6RSMF)E. Low Voltage CableF. Cable Termination CapD. Remote Driver andJunction BoxC. QuickLink Connector*Refer to the online Quick Start Guide for claiming and setup: support.BringHaloHome.com/SmartLightENGLISHPACKAGING CONTENTSITEMS REQUIRED (Purchase separately) OPTIONAL ITEMSA. Smart MicroEdge DownlightWhen using product, basic precautions should always be followed, including the following:• Heed all warnings, including below warnings AND those included on product.• HALO™ recessed luminaires (fixtures) are designed to meet the latest NEC requirements and are certified in full compliance with UL. Before attempting installation ofany recessed lighting luminaire check your local electrical code. This code sets the wiring standards for your locality and should be carefully studied before starting.• Read and follow these instructions.• Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.• Connect fixture to a 120 volt, 60 Hz power source. Any other connection voids the warranty.• Fixture should be installed by persons with experience in household wiring or by a qualified electrician. The electrical system, and the method of electrically connectingthe fixture to it, must be in accordance with the National Electrical Code and local building codes.• WARNING - Risk of fire or electric shock. Install this kit only in luminaires that have the construction features and dimensions shown in the photographs and/or drawingsand where the input rating of the retrofit kit does not exceed the input rating of the luminaire.IMPORTANT SAFETY INSTRUCTIONSRisk of Electric Shock -To avoid possible electrical shock,be sure that power supply isturned off at fuse box or circuitbreaker before installing orservicing luminaire.Risk of Fire - MINIMUM90°C SUPPLY CONDUCTORS. Ifuncertain, consult an electrician.Risk of Fire/ElectricShock - LED Retrofit Kitinstallation requires knowledgeof luminaires electrical systems.If not qualified, do not attemptinstallation. Contact a qualifiedelectrician. Luminaire wiring andelectrical parts may be damagedwhen drilling for installationof LED retrofit kit. Check forenclosed wiring and components.QuickLink Low Voltage Kit Installation InstructionsSmart MicroEdge™ Downlights: HLB QL6 and HLB QL4Edges may be Sharp -Wear gloves while handling. |
Related manuals for Halo home Smart MicroEdge HLB QL4
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved