Hakko Electronics FR-410 Instruction Manual

Also see for FR-410: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Hakko Electronics FR-410 Instruction Manual Manual pdf 5 page image

4Turn the powerswitch ON.Connect the hose.CAUTIONBe sure to hold the plug when inserting or removing the handpiece cord.C. Station● Connection1. Connect the power cord to the receptacle on therear of the station.2. Connect the plug from the HAKKO FR-4104to the receptacle on the HAKKO FR-410.CAUTIONConnect the plug to the receptacle, aligning the tabon the plug with the opening on the receptacle.3. Set the HAKKO FR-4102 in the handpiece holder.4. Connect the hose from the HAKKO FR-4104to the vacuum outlet cap on the HAKKOFR-410 station.5. Plug the power cord into a grounded power outlet.Ensure that the power switch is OFF before pluggingin the power cord.CAUTIONBe sure to ground this product as it is ESDsafe by design.6. Turn the power switch ON.Insert the plug intothe receptacle untilit seats.To disconnect, pull the plugfrom the receptacle whilepressing down the tab onthe plug.5. OPERATIONPART NAMESControlButtonsReceptacle Power Switch- Moving the cursor UP. Increases the value.- Moving the cursor DOWN.Decreases the value.- End of sequence (terminates a phaseof a data entry mode).UPDOWNENTERThe HAKKO FR-410 has three controlsVacuumoutlet capNormal display screen