4-5 Usage of the drain hoseThe drainage shall be smooth with the drain hose.1.put the drain hose up to suitable position.2.Do not step on or press the drain hose.<1.2mFigure 3Figure 2Figure 11. Insert a new flat washer into each end of the inlet hoses. Firmly seatthe washers in the coupling. ( As figure 1)2. ttach the water inlethoses to the water faucet . Usingpliers,tighten the coupling . ( As figure 2)NOTE: Do not overtighten. Damage to the valves can result.Respectively a5. Check for leaks(1). Swing the water inlet hose gently to confirm if it's suitable.(2). Turn on the water faucets and check for leaks. A small amount ofwater might enter the washers. You will drain this later.3. Run water through the faucets and inlet hoses, into a bucket or laundrytub, to get rid of particles in the water lines that might clog the inletvalves screens.4. Attach the hose connected with the water faucet to the water valve.( As figure 3)NOTE: Do not overtighten. Damage to the valves can result.Do not take off the water absorption cushion. Please check if the cushionis dropped or damaged before each usage. If it happens please contactour after-sale department immediately.Water absorption cushionFigure 4(As Figure 4)Service ManualModel No: HLP21NIssueRev.-10-