23VCR connectionTo avoid picture noise (interference), leave an adequate distancebetween the VCR and TVConnection Option 1Set VCR output switch to channel 3 or 4 andthen tune the TV to the same channel number.Connection Option 21. Connect the audio and video cables from theVCR's output jacks to the TV input jacks, asshown in the figure.When connecting the TV to VCR, match thejack colors (Video = yellow, Audio Left = white,and Audio Right = red).Ifyou connect an S-VIDEO output from VCR tothe S-VIDEO input, thepicture quality is improved; compared to connecting a regular VCR to the Video input.2. Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner`s manual.)3. Select the input source with using the INPUT button on the remote control, and then press ▲/▼ button to select thesource,press the ►button to confirm.External Equipment ConnectionsExternal A/V Source SetupHow to connectConnect the audio and video cables from the external equipment'soutput jacks to the TV input jacks, as shown in the figure.When connecting the TV to external equipment, match thejack colors (Video = yellow, Audio Left = white, and AudioRight = red).How to use1. Select the input source with using the INPUT button onthe remote control.2. Press the ?/ ?button to select the desired source.3. Press the ok button to confirm2. Operate the corresponding external equipment.How to connect1. Connect the DVD video outputs (Y, Pb/Cb, Pr/Cr) to the Y, Pb, Prjacks on the TV and connect the DVD audio outputs to the YPbPrAudio IN jacks on the TV, as shown in the figure.2. If your DVD only has an S-VIDEO output jack, connect this tothe S-VIDEO input on the TV. as shown in the figure.NOTE: If your DVD player does not have component video output,use S-Video.How to use1. Turn on the DVD player, insert a DVD.S- Video CVBS S- Video/CVBSAudio InL R R L VAV OUTR INPUTFVideo Game SetCamcorderS-Video CVBS S-Video/CVBSAudio InL R R L VAV OUTR INPUTFPr PbYD VI Audio IN YPbPrAudio InL RHeadphoneoutS-Video CVBS S-Video/CVBSAud io InL R