SERVICE MANUALMod el: HCM071PA8Issue 2013-11-21Rev. Ref1311S001V0freezer.Water may drip from the back flange of the lid cover during defrosting. This is normal. Icebuilds up in the lid insulation when the lid is open for adding or removing food, and melts during thedefrosting operation.3-3 Cleaning the FreezerOutside. Protect the paint finish. The finish on the outside of the freezer is a high quality baked-onpaint finish. With proper care, it will stay new-looking and rust-free for years. Apply a coat of appliancepolish wax when the freezer is new and then at least twice a year. Appliance polish wax also workswell to remove tape residue from freezer surfaces.Keep the finish clean. Wipe with a clean cloth lightly dampened with appliance polish wax or mildliquid dishwashing detergent. Dry and polish with a clean, soft cloth. Do not wipe the freezer with asoiled dishwashing cloth or wet towel. Do not use scouring pads, powdered cleaners, bleach, orcleaners containing bleach.Inside. Clean the inside of the freezer at least once a year. We recommend that the freezer beunplugged before cleaning. If this is not practical, wring excess moisture out of sponge or cloth whencleaning in the vicinity of switches, lights or controls.Use warm water and baking soda solution-about a tablespoon of baking soda to a quart of water.Rinse thoroughly with water and wipe dry. Do not use cleaning powders or other abrasive cleaners.An open box of baking soda in the freezer will absorb stale freezer odors. Change the box ever y threemonths.Care should be taken in moving the freezer away from the wall. All types of floor coverings canbe damaged particularly cushioned coverings and those with embossed surfaces.