Haier HBF 1055 TVE User Manual

Also see for HBF1055TVE: Instructions for use Owner's manual Energy guide Service manual

Haier HBF 1055 TVE User Manual Manual pdf 11 page image

English10INSTALLATIONConnection of water inlet hose andwashing machine• Connect the straight coupling of the inlet hoseto the water tap and make sure to tighten it.• Install the pressure regulator to each inlet valvesof the unit. Make sure the flat rubber washeris placed in the pressure regulator.• Connect the elbow coupling of the inlet hoseto the valve and make sure to tighten it.Note: • Please be sure that the COLD inlet hose isconnected with the valve for cold water(marked with "C").• Please be sure that the HOT inlet hose isconnected with the valve for hot water(marked with "H").Note: A flat rubber washer must be present inside each end of the inlet hoses.Over tightening may cause damage to the valve.Water Drainage Hose• The height of the pipe for the water drainagehose should be between 2'6" to 3'3". Thewater drain hose must be securely placedon the clip on the back of the washing machine.• Use the water drainage support (gooseneck)supplied as an accessory for proper installation.If the water drain hose needs to be extended,it should not be extended more than 8'2".(Longer extension will result in concurrent waterinflow and outflow.) The diameter of the extensionhose should be the same as the original hose.Caution: Water drainage hose must not be immersed in water. The original andextension hoses should be tightly connected..H100cm80cmPressure RegulatorWater Inlet HosesPressure Regulator