Haier GWT750AW User Manual

Also see for GWT750AW: Energy guide

Haier GWT750AW User Manual Manual pdf 8 page image

EnglishSteps for Installation• Select a suitable location for the washer on a hard even surface away fromdirect sunlight or heat source e.g. radiators, baseboard heaters, cookingappliances etc. Any floor unevenness should be corrected with the levelinglegs located on the bottom corners of the washer. The washer must be placedat room temperature. You must not place washer where the temperature is atbelow freezing.Installing Your WasherRead installation instructions carefully before installation.CAUTION: If, after completing these steps, you are unsure that unit is properlyinstalled, contact a qualified installer. To ensure that your washer isproperly installed it is recommended that it be installed by a certifiedinstaller.1. Do not use water inlet hoses without a flat washer on each end. The washerin the coupling has to be placed firmly. Flat water inlet hose washers arepreinstalled in each end of the water inlet hoses.NOTE: You may have to use pliers to tighten the coupling.Do not over tighten because you may cause damage to the valve.2. Connect the hot and cold water inlet hoses to the hot and cold water faucet.7