Haier GWT560BW User Manual

Also see for GWT560BW: User manual

Contents

Haier GWT560BW User Manual Manual pdf 23 page image

21TROUBLESHOOTINGERROR CODESWhen the washer senses an error all machine operations will stop, a series of 4beeps will sound and an error code will be shown in the Estimated Time Remainingdisplay.ERROR CODE DESCRIPTION POSSIBLE CAUSE AND SOLUTIONdO7I-6#(2,B!1,!6,A@()9The washer has detectedthat the lid is open.The washer will not start with thewasher lid open. If the lid is openedduring the wash cycle, it maycontinue to run. However, when itreaches a stage that requires thelid to be closed, the error will occur.Closing the lid should dismissthe error and resume normaloperation.Ld(Too Long to DrainI-/(29The washer has detectedthat it is taking too longto completely drain waterfrom the wash tub.Check to make sure the drain hoseis properly installed. The open endof the drain hose should not besubmerged in water.UL7J)K-4-)'(1,BL-19The washer has detectedan out of balance load andhas failed to self correctthe condition.Open the washer lid, redistributethe load, close the lid, and thewasher will resume operation.LF7GLL,BL)",/L,E!449The washer senses that it1/#& :1!6#&++#$+!6#&+#@$$#&'%#wash tub or does not reada change in water level"2)1!6# #@$$3Check to make sure that thewater hoses are connected to thewasher, there are no kinks in thehoses, and that the supply valvesare fully opened.FA(Water Level Sensor%22L29The washer has detectedwater level sensor errors. Call for Service.F2(Water Level is Too!"#9The washer has detectedhigher than normal waterlevels, automatic draininghas not resolved the issue.Call for Service.E5(Water TemperatureM2LK4(N9The washer senses thatHot water is too cold, orWarm, Cool, Cold, and TapCold water is too hot.Check to make sure that yourhot water heater is supplying hotwater. Check to make sure thatthe water hoses are connected tothe proper valve; hot to hot, coldto cold.WASHER DOES NOT OPERATE: Check that the power cord is plugged into a grounded 3 prong outlet.: Check that the electrical wall receptacle is of proper voltage.: Check if the circuit breaker needs to be reset or if the fuse needs to be replaced.