Menu
Hadley SAMS Owner's Service Manual
                | |
Raised ModeThis mode of operation is used to increase the clearance between the underside of the vehicle frame andthe ground surface. The vehicle operator must select this mode of operation and choose to raise either therear only of the vehicle or to raise the entire vehicle. A separate action must be performed by the vehicleoperator in order to initiate either function of the raised mode of operation. This action is furtherdiscussed in the following two paragraphs.Raising the rear only of the vehicle can be chosen by the vehicle operator to increase the clearancebetween the rear bumper of the vehicle and the ground. It may be necessary for the operator of thevehicle to select this mode when situations arise where the rear of the vehicle may drag due to the lengthof the vehicle and the departure angle. This mode may be selected by momentarily depressing the “raise”pushbutton located on the user interface, with the vehicle speed at 20MPH or less. Once the mode isselected, the system ECU will temporarily raise the rear of the vehicle and the LED located above thepushbutton on the user interface will blink as a visual indication the mode has been activated.The ECU will automatically return the rear of the vehicle to the normal ride height when the speedexceeds 20MPH, the mode has been active for more than 40seconds, or the operator momentarilydepresses the “lower” pushbutton located on the user interface. Once the mode has been deactivated, theECU will automatically turn off the LED.Raising the entire vehicle can be chosen by the vehicle operator to increase the clearance between theentire vehicle and the ground. It may be necessary for the operator of the vehicle to select this modewhen situations arise where the body of the vehicle must be raised to avoid or to overcome anundercarriage obstacle. This mode may be selected by depressing and holding the “raise” pushbutton forapproximately 3 seconds, with the vehicle speed at 10MPH or less. The pushbutton must be held until theLED located above the pushbutton remains on continuously. At that point, the pushbutton can be releasedand the mode will remain active. Once the mode becomes active, the system ECU will raise the entirevehicle and the LED located above the pushbutton will remain on as a visual indication the mode isactive.The ECU will automatically return the entire vehicle to the normal ride height when the speed exceeds10MPH or the operator momentarily depresses the “lower” pushbutton located on the user interface.Once the mode has been deactivated, the ECU will automatically turn off the LED.Lowered ModeThis mode of operation is used to decrease the clearance between the underside of the vehicle frame andthe ground surface. The vehicle operator must select this mode of operation and choose to partially loweror entirely lower the whole vehicle. A separate action must be performed by the vehicle operator in orderto initiate either function of the lowered mode of operation. This action is further discussed in thefollowing two paragraphs. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved