HP xw4600 Service And Technical Reference Manual

Also see for Xw4600 - Workstation - 2 GB RAM: Installation guidelines Brochure & specs Specification Safety and regulatory information User manual

Contents

WARNING! This workstation includes a lithium battery. There is a risk of fire and chemical burn if thebattery is handled improperly. Do not disassemble, crush, puncture, short external contacts, dispose inwater or fire, or expose it to temperatures higher than 60°C (140°F).CAUTION: Before removing the battery, ensure that the CMOS settings are backed up in case theyare lost when the battery is removed. To back up the CMOS settings, select the Save to Diskette optionin the Computer Setup (F10) Utility.NOTE: Batteries, battery packs, and accumulators should not be disposed of together with generalhousehold waste.Removing the batteryTo remove the battery:1. Disconnect power from the system (Predisassembly procedures on page 58) and remove the sideaccess panel (Removing the side access panel on page 64).2. On the system board, press the release tab of the battery holder.3. Rotate the battery just enough to get beyond the latch, and then lift it straight up.Installing the batteryTo install the battery:1. Confirm the polarity (positive or negative) of the battery to position it correctly in the battery holder.2. Place the battery edge under the plastic housing tab.Figure 4-35 Removing the battery3. Press down on the battery until the metal snaps engage.88 Chapter 4 Removal and replacement procedures ENWW