HP Xw4600 - Workstation - 2 GB RAM Read This First Manual

Also see for Xw4600 - Workstation - 2 GB RAM: Installation guidelines Brochure & specs Specification Safety and regulatory information User manual

Contents

read this first

Read This FirstSelecting and installing the card support bracket for HP400 and xw4000 series WorkstationsThis supplementary document describes how to select and install the expansion card support bracketfor HP 400 and xw4000 series Workstations.ProcedureTwo similar expansion card support brackets have been included with your graphics card kit.1. Select the expansion card support that fits your workstation.● For HP 400 Workstations, select the expansion card support bracket with the barcode labeland the smaller piece of pink foam attached.● For the HP xw4000 Workstation series, select the expansion card support bracket without thebarcode label and with the longer piece of pink foam attached.2. After installing the expansion graphics card and closing the expansion slot retention clamp, installthe expansion card support.a. Position the end of the card support above the expansion card retention clamp .b. Lower the card support into place 2.c. Secure the card support with two screws .Figure 1© 2009 Hewlett-Packard Development Company, L.P. Printed in the U.S.ENWW Selecting and installing the card support bracket for HP 400 and xw4000 series Workstations 1

/ 1

Related manuals for HP Xw4600 - Workstation - 2 GB RAM