HP Workstation xw8000 Configuration Manual

Also see for xw8600 - Workstation: Brochure & specs Safety and regulatory information User manual Compatibility chart Limited warranty

SATA device configuration guidelinesHP xw8x00 and xw9x00 WorkstationsThis document describes how to configure SATA devices in HP xw8x00 and xw9x00 Workstations.NOTE: SATA ports on the workstation are not hot swappable.1. Begin connecting the SATA mass storage device cables to the workstation SATA ports, typicallystarting with SATA port 0. The port 0 connector is identified by a unique color.NOTE: Refer to the service label on the inside of the workstation access panel for SATA and SASport details.Figure 1 SATA portsExample: HP xw8400 Workstation SATA ports Example: HP xw9400 Workstation SATA ports2. Continue connecting the mass storage devices to unused SATA ports.TIP: Connect the hard drives first. When all hard drives are connected, begin connecting theoptical devices.NOTE: All internal bay SATA hard drives are supported only on the system board SATA ports.An external SATA hard drive is supported on either an eSATA or a SAS controller card port.August 2009, 459722-002 HP xw8x00 and xw9x00 Workstations 1

/ 2

Related manuals for HP xw8600 - Workstation