HP StoreEasy 1000 Storage Administrator's Manual

Also see for StorageWorks 1000 - Modular Smart Array: Network guide Reference guide Technical white paper Firmware update Overview

Contents

6. Connection from the P822 controller to port 2 of I/O module A on the top D2600 in Group 27. Connection from the P822 controller to port 2 of I/O module B on the top D2600 in Group 28. SAS daisy chain – port 1 of I/O module B on the top D2600 connects to port 2 of I/O module B on the bottomD2600 and port 1 of I/O module A on the top D2600 connects to port 2 of I/O module A on the bottom D2600Connect to the storage systemUse either the direct attach or remote management method to connect to the storage system.IMPORTANT: Only the direct attach and remote management access methods can be used toinstall the storage system. After the storage system installation process is complete and the server’sIP addresses have been assigned, you can then additionally use the remote desktop method toaccess the storage system.• Direct attach —This access method is mandatory if your network does not have a DynamicHost Configuration Protocol (DHCP) server. Connect the following cables to the back panelof the storage system in the following sequence: keyboard, mouse, network cables, monitorcable, and power cable.NOTE: The keyboard, mouse, and monitor are not provided with the storage system.• Remote management—Access the storage system using the Integrated Lights-Out (iLO) remotemanagement method:1. Connect the desired network cables to network adapter ports on the back of the storagesystem.2. Connect a network cable to the iLO port located on the back of the storage system.3. Connect a power cable to the storage system.4. Locate the iLO Network Settings tag attached to the storage system and record the defaultuser name, password, and DNS name.5. From a remote computer, open a standard Web browser and enter the iLO managementhostname of the storage system.NOTE: By default, iLO obtains the management IP address and subnet mask from yournetwork’s DHCP server. The hostname found on the iLO tag is automatically registeredwith your network’s DNS server.6. Using the default user information provided on the iLO Network Settings tag, log on toiLO, and then launch a remote console to the storage system.For detailed instructions on using iLO remote management software, see the HP iLO 4User Guide.Power on the server and log on1. Power on the system by pushing the power button on the front panel. If using iLO, clickMomentary Press under the Power Switch menu of the remote console.The storage system starts and displays the Setup Windows wizard, in which you select languageand regional settings and accept the license agreement. The storage system installation processtakes approximately 10–15 minutes.2. When the storage system installation process nears completion, the Windows Storage Server2012 Standard Edition desktop displays the following message: The user's password mustbe changed before logging on the first time indicating that you must set a new password. Logon to the storage system by establishing an Administrator password:a. Click OK.b. Enter the Administrator password in the New password box.36 Installing and configuring the storage system