HP ProCurve J8162A Supplementary Manual

Also see for 6400cl: Supplementary guide Supplementary guide Installation and getting started guide Management and configuration guide Management guide

Configuring the Access Controller xl ModuleSyntax: enable extended-commandsChanges the CLI to the access controller extended commands context. A limited set of commands from the720wl CLI is provided here. See “Using the ACM’sExtended CLI” for more information.Syntax: exitLeaves the access controller context and returns the CLIto the global configuration context.Syntax: [no] ip address <<ip-addr>/<1-32> | <ip addr> <mask>>Statically configures the ip address and subnet maskfor the ACM. The no form removes the fixed ip addressand enables DHCP. (Default: DHCP)Syntax: [no] ip default-gateway Statically configures the numeric ip-addr of the defaultgateway. If DHCP is enabled, this command overridesthe default gateway supplied by DHCP.Syntax: [no] pageTurns on or off paging of the CLI command responsesand CLI command stack replay (the up arrow function).Syntax: terminal 2-1000> | width <61-1920>>length <2-1000> Sets the number of lines that are displayed between pauses when page is on. The initialsetting is inherited from the previous context. Thissetting remains in effect when this context is exited.width <61-1920> Sets the maximum line width to be usedfor CLI output or CLI input. Lines longer than thespecified value wrap to the next line. The initial settingis inherited from the previous context. This settingremains in effect when this context is exited.23