HP Metal Jet S100 User Manual

Also see for Metal Jet S100: Product documentation

2. Under Load job properties, tap Load recipe.3. Edit the values of the recipe as desired. See the summary of the editable parameters below.Which parameters you can edit depend on the permissions associated with your profile type.4. Tap Apply.Access through the settings menu1. From the left menu of the front panel, select the settings icon , then tap Utilities > Recipes, andthen the recipe that you want to view or edit.2. Edit the values of the recipe as desired. See the summary of the editable parameters below.Which parameters you can edit depend on the permissions associated with your profile type.3. Tap Apply.Editable parameters● Build height: The height of the job that will be printed.● Mixer speed: The rotation speed of the mixer. If activated, it is on during the whole process. Thisis intended only to help the mixer discharge, so it is not the parameter to change for performing amixing operation.● Front platform offset: The last movement of the front feeding platform during the refilling operation.It moves down the powder that remains inside the refiller.● Rear platform offset: The last movement of the rear feeding platform during the refilling operation. Itmoves down the powder that remains inside the refiller.● Platform speed: The velocity of the feeding platform during the refilling operation. Higher platformspeed will imply less vibration time of the powder inside the refiller. This may lead to less powdercompaction. If the platform speed is decreased or increased, the Slow dosing/Fast dosing processparameters should be adjusted accordingly.● Slow dosing: The dispensing frequency when low mass flow is required in the compaction andleveling operations. The parameter itself represents the time between each 180° rotation of therotary valve.50 Chapter 3 System operation