HP MSM720 Quick Start Manual

Also see for MSM720: Datasheet Specification Installation guide Installation guide

Contents

HP MSM720 Controllers QuickstartThis Quickstart shows you how to install the MSM720 Controllers. This information applies to the MSM720 Access Controller (J9693A, J9695A) and the MSM720Premium Mobility Controller (J9694A, J9696A). These products are hereafter referred to as controller. The controller works with HP access points to deliver ahigh-performance networking solution. For additional installation information, and instructions on how to initially configure the controller, see the HP MSM720Controllers Installation Guide, available at www.hp.com/support/manuals.Hardware overviewMSM720 front panel1: Power, Fault, and Locator LEDs2: LED Mode select button and Mode Indicator LEDs3: Four 10/100/1000 access network ports4: Two dual-personality Internet network ports5: Console port6: Test LED7: Reset and Clear buttons8: Port LEDs: Link (left) and Mode (right)Package contentsController, power adapter and cord, console cable, four mounting brackets,eight bracket screws, four rubber feet, and documentation.LEDsThere are three types of LEDs: Status LEDs (labeled 1 and 6 in the graphic),Port LEDs (8), and Port LED Mode indicators (2).Reset and Clear buttonsThe Reset and Clear buttons are accessible (with a paper clip) on thecontroller front panel (labeled 7 in the image to the left).• To reset the controller, either power cycle it or press and release the Resetbutton.• To reset the controller to factory defaults, press and quickly release the Resetbutton, and then immediately press and hold the Clear button until the LEDsabove the Clear button flash three times.PortsController console port: A standard serial port with an RF-45 connector. Toconnect to a computer, use the supplied DB-9 to RJ-45 console cable.Access network: Four auto-sensing 10/100/1000 Base-T ports with theAuto-MDX feature. You can use either straight-through or crossovertwisted-pair cables to connect network devices to the controller.Internet network: Two dual personality ports for either 10/100/1000 Base-TRJ-45(Auto-MDX) uplinks or optional SFP slots for fibre uplinks.1 2735 6 845998-7941_QS_MSM720_2015-06-05.fm Page 1 Wednesday, June 10, 2015 2:01 PM