HP LC2000r - NetServer - 128 MB RAM Installation Manual

Also see for D5970A - NetServer - LCII: Installation guide Installation guide Specification sheet Installation guide Installation guide

NoticeThe information contained in this document is subject to changewithout notice.Hewlett-Packard makes no warranty of any kind withregard to this material, including, but not limited to, theimplied warranties of merchantability and fitness for aparticular purpose. Hewlett-Packard shall not be liable forerrors contained herein or for incidental or consequentialdamages in connection with the furnishing, performance, or useof this material.Hewlett-Packard assumes no responsibility for the use orreliability of its software on equipment that is not furnished byHewlett-Packard.This document contains proprietary information that is protectedby copyright. All rights are reserved. No part of this documentmay be photocopied, reproduced, or translated to anotherlanguage without the prior written consent of Hewlett-PackardCompany.Hewlett-Packard CompanyNetwork Server DivisionTechnical Communications/MS 45S-LE10955 Tantau AvenueCupertino, CA 95014 USA© Copyright 1998, Hewlett-Packard CompanyLH 4InstallationRoad MapHP NetServer5967-5281Printed on recycled paper.Printed in November 1998Audience AssumptionsThis road map is intended for the person who installs, administers,and troubleshoots LAN servers. Hewlett-Packard Company assumesthat you are qualified in the servicing of computer equipment andtrained in recognizing hazards in products with hazardous energylevels.ESD WarningTools RequiredThis HP NetServer contains sensitive electronic devices that can bedamaged by electrostatic discharge (ESD). ESD hazards are a resultof installation or service personnel failing to ground themselvesproperly. To be properly grounded, use a proper ESD wrist strap andwork surface grounded to the HP NetServer chassis.Installation of some accessories require a T25 TORX and T15 TORXor a 1/4-inch flat blade screwdriver, depending on the accessory.® ®1. Verify Contents2. Overview of NetServer Features3. Obtain Release History4. Connect Monitor, Keyboard, and Mouse5. Preparation6. Removing and Replacing the Covers7. Install All Accessory Boards8. Install Additional Memory9. Install Additional Mass Storage Devices10. Replace Covers and Cables11. Verify Installed Accessories (Optional)12. Configure the HP NetServerHP NetServer Navigator CD-ROMNetServer LH 4 Installation Road Map1 Verify ContentsUnpack and verify the contents of the shipping box against the Contents Checklist included with your HP NetServer. If anything is missing or damaged,contact your reseller.