104Task CommandDisplay information about MPLS TE tunnelinterfaces. display mpls te tunnel-interface [ tunnel number ]Display information about PCEs discovered byOSPF.display ospf [ process-id ] [ area area-id ] mpls te pce[ originate-router advertising-router-id | self-originate ]Display link and node information in an OSPFTEDB.display ospf [ process-id ] [ area area-id ] mpls teadvertisement [ originate-router advertising-router-id |self-originate ]Display network information in an OSPF TEDB.display ospf [ process-id ] [ area area-id ] mpls tenetwork [ originate-router advertising-router-id |self-originate ]Display OSPF tunnel interface information. display ospf [ process-id ] [ area area-id ] mpls tetunnelClear PCC and PCE statistics. reset mpls te pce statistics [ ip-address ]MPLS TE configuration examplesEstablishing an MPLS TE tunnel over a static CRLSPNetwork requirementsSwitch A, Switch B, and Switch C run IS-IS.Establish an MPLS TE tunnel over a static CRLSP from Switch A to Switch C to transmit databetween the two IP networks.The MPLS TE tunnel requires a bandwidth of 2000 kbps. The maximum bandwidth of the link that thetunnel traverses is 10000 kbps. The maximum reservable bandwidth of the link is 5000 kbps.Figure 32 Network diagramConfiguration procedure1. Configure IP addresses and masks for interfaces. (Details not shown.)2. Configure IS-IS to advertise interface addresses, including the loopback interface address:# Configure Switch A. system-viewLoop02.2.2.2/32Vlan-int12.1.1.2/24Vlan-int23.2.1.1/24Vlan-int12.1.1.1/24Vlan-int23.2.1.2/24Loop01.1.1.1/32Loop03.3.3.3/32Switch A Switch CSwitch BIP networkIP networkVlan-int10100.1.1.1/24Vlan-int10100.1.2.1/24
