54lower-threshold: Specifies the lower limit in the range of 1 to 100. It must not be greater than the upperlimit.action-type: Specifies what action to be triggered. The default action is none.none: Specifies the action of only displaying results on the terminal display.trap-only: Specifies the action of displaying results on the terminal display and meanwhile sendingSNMP trap messages to the NMS.Usage guidelinesYou cannot edit a reaction entry after it is created. To change the attributes in a reaction entry, use undoreaction to delete the entry first and reconfigure a new one.Examples# Create reaction entry 1 for monitoring the ICPIF value in the voice operation, setting the upper limit to50 and lower limit to 5. Before the voice operation starts, the initial state of the reaction entry is invalid.After the operation, the ICPIF value is checked against the threshold range. If it exceeds the upper limit,the state of the reaction entry is set to over-threshold. If it is below the lower limit, the state is set tobelow-threshold. Once the state of the reaction entry changes, a trap message is generated and sent tothe NMS. system-view[Sysname] nqa entry admin test[Sysname-nqa-admin-test] type voice[Sysname-nqa-admin-test-voice] reaction 1 checked-element icpif threshold-value 50 5action-type trap-onlyreaction checked-element { jitter-ds | jitter-sd }Use reaction checked-element { jitter-ds | jitter-sd } to configure a reaction entry for monitoring one-wayjitter in the NQA operation.Use undo reaction to delete the specified reaction entry.Syntaxreaction item-number checked-element { jitter-ds | jitter-sd } threshold-type { accumulateaccumulate-occurrences | average } threshold-value upper-threshold lower-threshold [ action-type{ none | trap-only } ]undo reaction item-numberDefaultNo reaction entry for monitoring one-way jitter is configured.ViewsUDP jitter operation view, voice operation viewPredefined user rolesnetwork-adminmdc-adminParametersitem-number: Assigns an ID to the reaction entry, in the range of 1 to 10.