HP D7171A - NetServer - LPr Software Install Manual

Also see for D5970A - NetServer - LCII: Installation guide Installation guide Specification sheet Installation guide Installation guide

Contents

1IBM OS/2 Installation Guidefor all Hewlett-Packard NetServersNOTICE: The information in this document was last updated for the HP NetServer Navigator CD-ROM version E.10.00 orL.16.00. If you don't have the E.10.00 or L.16.00 version CD-ROM and you're obtaining this document from the HP NetServerweb site as a reference to install an operating system, be sure to also check the HP NetServer web site for the latest availabledrivers.©Copyright Hewlett-Packard CompanyMarch 19, 1999(This document is only available in English.)IntroductionThe objective of this document is to help Hewlett-Packard customers install OS/2 on a HPNetServer system. For additional information on Hewlett-Packard NetServers refer to the HPInformation Assistant on the HP NetServer Navigator CD-ROM.Table of ContentsBefore You BeginSection 1. Installation Tips and ConsiderationsTip 1) Extended Translation SettingTip 2) Extending Disk Capacity Beyond 1 GBTip 3) Formatting Disk Partitions Larger than 2 GBTip 4) Device Allocation Under OS/2Tip 5) RAM Greater Than 192 MBTip 6) Performance TuningTip 7) Troubleshooting System Hangs When Loading CONFIG.SYSTip 8) OS/2 Warp Server Installation IssuesTip 9) How to View the Resources Used by an AdapterTip 10) How to Run the HPVGSET.EXE Utility from the Navigator CD-ROMTip 11) 4GB RAM Support in OS/2Tip 12) HPFS386 Drive cache size issue on systems with 4GB RAMTip 13) When using HP NetRAID install the driver MRAID.ADDTip 14) Getting Trap 00D when booting OS/2Tip 15) Getting Trap 008 during extensive disk/network I/OTip 16) Specific to E Series NetServers: How to boot from a NetRAID adapter while a2910Bui SCSI card is present on the systemTip 17) IRQ sharing can cause system hangsTip 18) Adaptec driver AIC7870.ADD 133496 12-Jan-1998 or later is required for 2940UWwith rev B chip set