ENWW Chapter 7 Troubleshooting 2238-bin mailbox control panel and event log messagesNote Numerical messages are listed first, followed by the alphabetical messages.Table 30. Control panel and event log messages—8-bin mailboxControl panel message Event log User LED Service LED Description13.12.01Jam in left accessory13.12.01 Amber blinking Red blinking An initial jam exists in the flipper. Atpower-on the ENTRY or FACEUP sensoris activated.Recommended action:1 Make sure that the flipper path area is clear.2 Clear the jam.3 Check the sensor diagram for sensor-position identification.4 Make sure that the flipper sensors are in the correct position and that there are no loose parts onthe module.5 Make sure that the flipper connections are correct.6 Make sure that the controller PCA connections are correct.7 Make sure that the grounding line is in good condition by checking the electrical continuitybetween the guide beam and the specific point of the line.8 If the error persists, replace the flipper.13.12.02Jam in left accessory13.12.02 Amber blinking Red blinking A delay jam exists in the entry sensor.The timeout to receive media expiredbefore the sheet reached the ENTRYsensor.Recommended action:1 Check the event log to see if jams (fuser duplexer) are related to media not arriving in time.2 Make sure that the media is not wrinkled or damaged.3 Make sure that the 8-bin mailbox has the latest firmware version.4 Make sure that the correct media type is being used in the printer or MFP.5 Check if the error occurs when non-standard media is used.6 Use standard media to see if the jam persists.7 Make sure that the grounding line is in good condition by checking the electrical continuitybetween the guide beam and the specific point of the line.8 If the error persists, replace the flipper.13.12.03Jam in left accessory13.12.03 Amber blinking Red blinking A stay jam exists in the entry sensor. TheENTRY sensor remains activated longerthan expected.Recommended action:1 Check the event log to see if the jam is occurring at a repetitive rate (for example, more thanthree occurrences in less than 1,000 printed pages).2 Make sure that the media is not wrinkled or damaged.3 Make sure that the correct media size is being used in the printer or MFP.4 Remove the 8-bin mailbox from the printer or MFP, and then reattach it.5 Make sure that the flipper rollers move freely.6 Perform a paper-path test to see if the error can be reproduced.7 Check to see if an obstruction exists in the paper path.8 Make sure that the correct media type is being used in the printer or MFP.9 Check if the error occurs when non-standard media is used.10 Use standard media to see if the jam persists.11 Check the sensor diagram for sensor-position identification.12 Make sure that the grounding line is in good condition by checking the electrical continuitybetween the guide beam and the specific point of the line.13 Replace the flipper if more than three jams occur in less than 1,000 jobs and if the customer isusing standard media.
