. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Appendix BPower Cord Set Requirements B-1Power Cord SetRequirements3-Conductor Power Cord SetThe wide range input feature of the Broadway Family of Personal Computers permits itto operate from any line voltage from 100 to 120 or 220 to 240 volts AC.The power cord set received with the computer meets the requirements for use in thecountry where the equipment is purchased.Power cord sets for use in other countries must meet the requirements of the countrywhere the computer is used. For more information on power cord set requirements,contact a Compaq authorized reseller or service provider.General RequirementsThe requirements listed below are applicable to all countries:1. The length of the power cord set must be at least 5.00 feet (1.5 m) and a maximumof 6.50 feet (2.0 m).2. All power cord sets must be approved by an acceptable accredited agencyresponsible for evaluation in the country where the power cord set will be used.3. The power cord set must have a minimum current capacity of 10A and a nominalvoltage rating of 125 or 250 volts AC, as required by each country’s power system.4. The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC320 Standard Sheet C13 connector, for mating with appliance inlet on the back of thecomputer.