HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual

Also see for rp2400 Series: Limited warranty Limited warranty Programmer's guide Manual Release note

rp24xx_cable_change_listv1Printed in the U.S.A.Basic Cable Connections - HP rp2400 Series of Servers - Document ChangesThe document Basic Cable Connections - HP rp2400 Series of Servers has been revised. See the table below.IMPORTANT The latest versions of these documents, and any updates to these documents, are posted underthe appropriate server at http://docs.hp.com.Ver. 1.0Page #Ver. 2.0Page # Description of Change2 2 Send documentation comments to http://docs.hp.com/assistance/index.html.3 7 For detailed installation, maintenance, and technical information, refer to therp24xx Hardware Manual and other documentation (search on rp2400) athttp://docs.hp.com.4 8 2. (Amber) Attention (ATTN) LED - When lit, indicates that a condition exists thatrequires operator attention and assistance from HP Support.NOTE: For technical support please call your local support hotline or contact HPat http://www.hp.com/support.5 9 NOTE: For more information on console configuration, refer to the rp24xxHardware Manual (search on rp2400) at http://docs.hp.com.Using a Secure Web Console PCI card as a System Console. If the SecureWeb Console PCI card is to be used as a system console, first configure theGuardian Service Processor (GSP). For more information on GSP configuration,refer to the rp24xx Hardware Manual (search on rp2400) at http://docs.hp.com.Then, connect an RJ45 LAN cable to the Secure Web Console PCI card installedin an I/O card slot on the back of the server.6 10 Using the LAN Console as a System Console. If a LAN Console is to be usedas a system console, first configure the Guardian Service Processor (GSP). Formore information on GSP configuration, refer to the rp24xx Hardware Manual(search on rp2400) at http://docs.hp.com.Then, connect it to the system with an RJ45 LAN cable to the RJ45 connectorlabeled 10BASE-T LAN Console connection on the back of the server.6 10 NOTE: [regarding connecting Power Distribution Units (PDUs) to Dedicated ACInput Receptacles] Current requirements vary with input voltage, serverconfiguration, and number of power supplies installed. Refer to “System SitePreparation” in the rp24xx Hardware Manual at http://docs.hp.com.

/ 1

Related manuals for HP rp2400 Series