HP 9000 Series Instruction Manual

Also see for 9000 Series: INSTALLATION REFERENCE Service information manual Upgrade manual Handbook Hardware Support Document

22 Chapter 1Installing and Configuring 10/100Base-TX/9000Step 2: Loading 10/100Base-TX SoftwareStep 2: Loading 10/100Base-TX SoftwareFollow the steps below to load 10/100Base-TX /9000 software using theHP-UX swinstall program.1. Log in as root.2. Insert the software media (tape or CD) into the appropriate drive.3. Run the swinstall program using the command:swinstallThis opens the Software Selection Window and Specify SourceWindow of the swinstall program.4. Change the Source Host Name, if necessary, enter the mount point ofthe drive in the Source Depot Path field, and activate the OK buttonto return to the Software Selection Window. Activate the Help buttonto get more information.The Software Selection Window now contains a list of availablesoftware bundles to install.5. Highlight the HP-PB 10/100Base-TX/9000 software.6. Choose Mark for Install from the “Actions” menu to choose theproduct name(s) is to be installed.7. Choose Install from the “Actions” menu to begin productinstallation and open the Install Analysis Window.8. Activate the OK button in the Install Analysis Window when theStatus field displays a Ready message.9. Activate the Yes button at the Confirmation Window to confirm thatyou want to install the software. swinstall displays the InstallWindow.View the Install Window to read processing data while the software isbeing installed. When the Status field indicates Ready and the NoteWindow opens. swinstall loads the fileset, runs the control scripts forthe fileset, and builds the kernel. Estimated time for processing: 3 to5 minutes.10. Activate the OK button on the Note Window to reboot the system.The user interface disappears and the system reboots.Download from Www.Somanuals.com. All Manuals Search And Download.