2defaultUse default to restore the default settings for an Ethernet interface.SyntaxdefaultViewsEthernet interface viewDefault command level2: System levelUsage guidelinesCAUTION:The default command might interrupt ongoing network services. Make sure you are fully aware of theimpacts of this command when you use it in a live network.This command might fail to restore the default settings for some commands for reasons such as commanddependencies and system restrictions. Use the display this command in interface view to identify thesecommands, and then use their undo forms or follow the command reference to individually restore theirdefault settings. If your restoration attempt still fails, follow the error message instructions to resolve theproblem.Examples# Restore the default settings for interface Ten-GigabitEthernet 1/0/1. system-view[Sysname] interface ten-gigabitethernet 1/0/1[Sysname-Ten-GigabitEthernet1/0/1] defaultThis command will restore the default settings. Continue? [Y/N]:ydescriptionUse description to change the description of the interface.Use undo description to restore the default.Syntaxdescription textundo descriptionDefaultThe default description of an interface is the interface name plus Interface. For example,Ten-GigabitEthernet1/0/1 Interface.ViewsEthernet interface viewDefault command level2: System level
