HP Disk Enclosure Fan ModuleReplacement Instructions© Copyright 2009–2011 Hewlett-Packard Development Company, L.P.Printed in Puerto RicoPart number: 5697-0978Published: June 2011Edition: ThirdAbout this documentFor the latest documentation, go to http://www.hp.com/support/manuals, and select your product.The information contained herein is subject to changewithout notice. The only warranties for HP products andservices are set forth in the express warranty statementsaccompanying such products and services. Nothingherein should be construed as constituting an additionalwarranty. HP shall not be liable for technical or editorialerrors or omissions contained herein.WARRANTY STATEMENT: To obtain a copy of thewarranty for this product, see the warranty informationwebsite: http://www.hp.com/go/storagewarrantyBefore you beginObserve the following precautions when replacing a fanmodule.CAUTION: Removing a fan module significantlychanges the air flow within the enclosure. Both fanmodules must be installed for the enclosure to coolproperly. If a fan module fails, leave it in place inthe enclosure until a new fan is available to install.Parts can be damaged by electrostatic discharge.Use proper anti-static protection. Refer to thedocumentation that shipped with your system foradditional information.NOTE: Port-colored (purple) latches oncomponents like the fan module means thecomponent is hot-swappable. It can be removedand replaced without having to power the systemdown.There are two fan modules on the back of the diskenclosure. See Figure 1 (page 1) for thelocations.Figure 1 Fan module locations2. Fan 21. Fan 1Page 1