HP 4400 Replacement Instructions Manual

Also see for Compaq Presario,Presario 4400: Reference Quickspecs Introduction Install guide Supplementary guide

Contents

HP Controller EnclosureManagement ModuleReplacement Instructions© Copyright 2009 Hewlett-Packard Development Company, L.P.Second edition: May 2011The information in this document is subject to change without notice.Printed in Puerto Ricowww.hp.com*593094-001*About this documentFor the latest documentation, go to http://www.hp.com/support/manuals, and select your product.The information contained herein is subject to change without notice.The only warranties for HP products and services are set forth in theexpress warranty statements accompanying such products and services.Nothing herein should be construed as constituting an additionalwarranty. HP shall not be liable for technical or editorial errors oromissions contained herein.WARRANTY STATEMENT:To obtain a copy of the warranty for this product, see the warrantyinformation website:http://www.hp.com/go/storagewarrantyBefore you begin• Port-colored (purple) latches on components like the managementmodule means the component is hot-swappable. The managementmodule can be removed and replaced without having to power thesystem down.• The management module is located on the rear of the chassis, abovethe controllers. See Figure 1.• Your controller enclosure model may vary slightly from what is illus-trated in this document.1. Management moduleFigure 1 Management module location.Verifying component failureUse the following methods to verify component failure:• Check the management module status using HP P6000 CommandView:1. In the navigation pane, select Storage System > Hardware >Controller Enclosure > Management Module.2. In the Management Module Properties window, check the status.An operational state of (Failed) would indicate a fault thatmay require a replacement.3. To help identify the correct enclosure, select Controller Enclosurein the navigation pane, and then click Locate > Locate On in thecontent pane. This causes the blue UID indicator to blink on thecontroller enclosure.• Check the array management module LEDs:Page 1

/ 2

Related manuals for HP Compaq Presario,Presario 4400