HP 1810-48G Quick Setup Manual

Also see for 1810-48G: Specifications Quickspecs Datasheet Quickspecs

1HP 1810-48G Switch Quick Setup GuideThe switch drawings in this document are for illustration only and may not match your particular switch model.For more detailed instructions and information to set up your switch, view or download the Installation and Getting StartedGuide for your switch at www.hp.com/networking/support.1. Unpack and check included parts. ■ Documentation kit■ Switch■ Accessory kit (installation hardware)■ AC power cord2. Prepare for installation. To avoid personal injury or product damage, review the “Safety Precautions” onpage 4.3 . Power on and verify that Self-Test completes normally. The switch does not contain a power switch. It is turned onby connecting power through the AC power cord.4. Install the Switch Hardware. Turn off the switch before installing the switch hardware.Rack Mounting: Use a #1 Phillips (cross-head) screwdriver to attach the accessory kit brackets to the switch using theeight 8-mm M4 screws. Then use the four number 12-24 screws to secure the brackets to the rack.Table or Desktop: Attach the four self-adhesive pads(included in the accessory kit) to the bottom corners ofthe switch.After Self-Test:Power LED = OnFault LED = Off

/ 5

Related manuals for HP 1810-48G