HP 16-port SCS Installation Instructions Manual

Contents

SCS commands 67Server SSH commandThe Server SSH command enables or disables SSH session access to the SCS and specifies the SSH authenticationmethod. When you enable SSH, all SCS sessions will be terminated if an SCS SSH server key must be generated.You must also have previously specified an authentication method other than None with the Server Securitycommand.If you enable plain text Telnet connections with a Server Security command, enabling SSH session access withthe Server SSH command will add that as a valid connection method (both plain text and SSH connections will beallowed.) See “Using SSH.”Access right: SCONAccess level: APPLIANCEADMINSyntax:server ssh enable|disable [auth=]Table 5-27 Server SSH command parametersParameter DescriptionENABLE|DISABLE Enables or disables SSH session access to the SCS.AUTH= SSH authentication methods. You must enter the entire value. Abbreviations are not permitted. Validvalues are:PW Password authenticationKEY Key authenticationPW|KEY Password or key authenticationKEY|PW Key or password authenticationPW&KEY Password and key authenticationKEY&PW Key and password authenticationDefault = PWShow commandsThe Show command has several forms, as listed in Table 5-28.Table 5-28 Show command summaryCommand DescriptionShow NFS Displays NFS mount status and configured valuesShow NTP Displays configured NTP valuesShow Port Displays port informationShow Port In/Out Displays how carriage returns and linefeeds are treatedShow Server Displays SCS configuration information and statisticsShow Server CLI Displays SCS CLI settingsShow Server PPP Displays SCS PPP settingsShow Server RADIUS Displays SCS RADIUS settingsShow Server Security Displays SCS authentication, connection, and security lock-out settingsShow Server SNMP Displays SNMP configuration informationShow User Displays user configuration and session informationShow NFS commandThe Show NFS command displays NFS configuration information and the current mount status. If a mount erroroccurred, the display also includes the error message returned by the NFS server.If NFS has never been enabled on the SCS, the default values appear. If NFS was previously enabled, successfullyconfigured, then later disabled, the display will retain the configured address, mount point, and file type values.