HP 12500 Series Installation Manual

Also see for 12500 Series: Specification Datasheet Quickspecs Configuration guide Configuration guide

Contents

96Figure 75 Replacing a CF cardReplacing a transceiver moduleThe replacement procedures of XFP, SFP+, and SFP transceiver modules are similar. This section takes anSFP transceiver module as an example.CAUTION:When installing or removing an SFP transceiver module, do not touch the golden finger of the SFPtransceiver module.To replace a transceiver module:1. Put on an ESD-preventive wrist strap, making sure that the strap makes good skin contact and iswell grounded.2. Remove the optical fibers from the SFP transceiver module, pivot the clasp down to the horizontalposition, and then pull SFP the transceiver module out of the socket, as shown in Figure 76.3. Put the removed SFP transceiver module in an antistatic bag or its original shipping materials.4. Unpack a new SFP transceiver module, pivot the clasp of the SFP transceiver module upward to thevertical position so that it catches a knob on the top of the SFP transceiver module, and then,holding both sides of the SFP transceiver module, gently push the SFP transceiver module into thesocket until it has close contact with the socket (you can feel that the top and bottom spring tabscatch in the socket), as shown in Figure 77.5. Connect the optical fibers to the new SFP transceiver module.