HP 12500 Series Configuration Manual

Also see for 12500 Series: Specification Datasheet Quickspecs Configuration guide Configuration guide

Contents

182To do… Use the command… RemarksClear the traffic statistics for aservice instance on an interfacereset service-instance statistics [ interfaceinterface-type interface-number[ service-instance instance-id [ inbound |outbound ] ] ]Available in user viewMPLS L2VPN configuration exampleNOTE:By default, Ethernet interfaces, VLAN interfaces, and aggregate interfaces are in DOWN state. Toconfigure such an interface, first use the undo shutdown command to bring the interface up.Configuring a Martini MPLS L2VPN connection based on Layer2 Ethernet interface and VLANNetwork requirementsCEs are connected to PEs through VLAN interfaces.Establish a Martini MPLS L2VPN connection between CE 1 and CE 2.Figure 45 Network diagramDevice Interface IP address Device Interface IP addressCE 1 Vlan-int10 100.1.1.1/24 P Loop0 192.4.4.4/32PE 1 Loop0 192.2.2.2/32 Vlan-int20 10.1.1.2/24Vlan-int20 10.1.1.1/24 Vlan-int30 10.2.2.2/24CE 2 Vlan-int10 100.1.1.2/24 PE 2 Loop0 192.3.3.3/32Vlan-int30 10.2.2.1/24Configuration procedure1. Configure CE 1. system-view[Sysname] sysname CE1[CE1] interface vlan-interface 10[CE1-Vlan-interface10] ip address 100.1.1.1 24