165[SwitchB-Tunnel0] ipv6 address 3001::2/64[SwitchB-Tunnel0] source vlan-interface 100[SwitchB-Tunnel0] destination 192.168.100.1[SwitchB-Tunnel0] tunnel-protocol ipv6-ipv4# Apply service loopback group 1 on the tunnel interface.[SwitchB-Tunnel0] service-loopback-group 1[SwitchB-Tunnel0] quit# Configure a static route to IPv6 Group 1 through Tunnel 0 on Switch B.[SwitchB] ipv6 route-static 3002:: 64 tunnel 0Verifying the configuration# Display the status of the tunnel interfaces on Switch A and Switch B, respectively.[SwitchA] display ipv6 interface tunnel 0Tunnel0 current state :UPLine protocol current state :UPIPv6 is enabled, link-local address is FE80::C0A8:6401Global unicast address(es):3001::1, subnet is 3001::/64Joined group address(es):FF02::1:FF00:0FF02::1:FF00:1FF02::1:FFA8:6401FF02::2FF02::1MTU is 1480 bytesND reachable time is 30000 millisecondsND retransmit interval is 1000 millisecondsHosts use stateless autoconfig for addressesIPv6 Packet statistics:InReceives: 55...[SwitchB] display ipv6 interface tunnel 0Tunnel0 current state :UPLine protocol current state :UPIPv6 is enabled, link-local address is FE80::C0A8:3201Global unicast address(es):3001::2, subnet is 3001::/64Joined group address(es):FF02::1:FF00:0FF02::1:FF00:1FF02::1:FFA8:3201FF02::2FF02::1MTU is 1480 bytesND reachable time is 30000 millisecondsND retransmit interval is 1000 millisecondsHosts use stateless autoconfig for addressesIPv6 Packet statistics:
