HP 10500 Series Configuration Manual

Also see for 10500 series: Specifications Datasheet Command reference Datasheet Specifications

Contents

280[PE1-Ten-GigabitEthernet1/0/1-srv1000] xconnect vsi aaa[PE1-Ten-GigabitEthernet1/0/1-srv1000] quit[PE1-Ten-GigabitEthernet1/0/1] quit3. Configure PE 2:# Configure basic MPLS. system-view[PE2] interface loopback 0[PE2-LoopBack0] ip address 2.2.2.9 32[PE2-LoopBack0] quit[PE2] mpls lsr-id 2.2.2.9[PE2] mpls ldp[PE2-ldp] quit# Enable L2VPN.[PE2] l2vpn enable# Configure VSI aaa that uses LDP as the PW signaling protocol, and establish a PW with PE 1 andPE 3, respectively.[PE2] vsi aaa[PE2-vsi-aaa] pwsignal ldp[PE2-vsi-aaa-ldp] peer 1.1.1.9 pw-id 500[PE2-vsi-aaa-ldp-1.1.1.9-500] quit[PE2-vsi-aaa-ldp] peer 3.3.3.9 pw-id 500[PE2-vsi-aaa-ldp-3.3.3.9-500] quit[PE2-vsi-aaa-ldp] quit[PE2-vsi-aaa] quit# Create service instance 10 on Ten-GigabitEthernet1/0/1, and bind the service instance to theVSI aaa.[PE2] interface ten-gigabitethernet 1/0/1[PE2-Ten-GigabitEthernet1/0/1] service-instance 1000[PE2-Ten-GigabitEthernet1/0/1-srv1000] encapsulation s-vid 100[PE2-Ten-GigabitEthernet1/0/1-srv1000] xconnect vsi aaa[PE2-Ten-GigabitEthernet1/0/1-srv1000] quit[PE2-Ten-GigabitEthernet1/0/1] quit4. Configure PE 3:# Configure basic MPLS. system-view[PE3] interface loopback 0[PE3-LoopBack0] ip address 3.3.3.9 32[PE3-LoopBack0] quit[PE3] mpls lsr-id 3.3.3.9[PE3] mpls ldp[PE3-ldp] quit# Enable L2VPN.[PE3] l2vpn enable# Configure VSI aaa that uses LDP as the PW signaling protocol, and establish a PW with PE 1 andPE 2, respectively.