Item #XXXX XXX XXXModel #HD41247Use and Care GuideSOLAR STEP LIGHTSPACKAGE CONTENTSAssembly and Installation1 Attaching and installing the light2 Replacing the batteryPlease read and save these instructionsq Using the 2X screws and 2X anchors supplied, install the unit (A).Screws should be installed to match the 2 slots in the rear of the unit (A).q Remove the 4 battery cover screws.q Remove the battery cover.q Remove the old battery and replace with 1 new AA NiMhrechargeable battery of same or greater mAh. USERECHARGEABLE BATTERIES ONLY.q Be sure to insert the battery in proper direction.q Replace the battery cover.q Replace the 4 screws.ABCABatteryScrewsBattery coverANOTE: This operation should be done in the morning on a sunny day. This will allowthe light to receive a full 8 hours of sunlight so that the rechargeable battery can reachmaximum capacity.Note : Clean the battery contacts and those of the device prior to battery installation.Part Description QuantityA Solar Wall Lights 4B Screws 8C Anchors 8CCWoodConcreteANOTE: If the solar panel is covered by a protective film, remove it before using theproduct. Remove the pull-tab from the battery door. Place the solar light in a locationwhere it can receive a full 8 hours of sunlight to allow the rechargeable battery/batteriesto reach maximum capacity.