HAMPTON BAY 191-707 Installation Manual

Also see for 191-707: Installation

HAMPTON BAY 191-707 Installation Manual Manual pdf 1 page image

Model No.: 191-707Vendor No.: 11289UPC# 792145326670REMOTE CONTROL INSTALLATIONGENERAL INFORMATIONThis remote control is designed to separately control your ceiling fan speed and light brightness. There are fourbuttons (Hi, Med, Low, off) to control the fan speed and off. The light dimmer button will control the lightbrightness dimmer and off. The red indicator on the transmitter will light when the button is pressed.1. SETTING THE CODEThis unit has 16 different code combinations. To set the code, performthese steps:A: Setting the code on the transmitter.a. Remove battery cover. Press firmly below arrow and slide batterycover off.b. Slide code switches to your choice of up or down position.(Factory setting is all up. Do not use this position. Use a smallscrewdriver or ball point pen to slide firmly up or down (Fig. 1).B: Setting the code on the receiver:a. Slide code switches to the same positions as set on your transmitter(Fig. 2).b. Replace battery cover on transmitter.2. INSTALLING RECEIVER IN CEILING FANA: Safety precautions:WARNING: HIGH VOLTAGE! Disconnect source of electricalpower by removing fuse or switching off circuit breaker.Do not use with solid state fans.Electrical wiring must meet all local and national electrical coderequirements.Electrical source and fan must be 115/120 volt, 60Hz. Maximum fanmotor amps: 1.0 Maximum light watts: 300-incandescent only.Household electrical power can cause serious injury or death!B: Installing receiver in fan:a. Remove electrical power from the circuit.b. Remove ceiling fan canopy from the mounting bracket.c. Disconnection existing wiring between ceiling fan and supply atelectrical junction box.d. Make connections as follows, using the wire nuts supplied:CONNECT TOGreen fan wire…………………….Bare supply wireBlack receiver wire (AC IN L)……Black supply wireWhite receiver wire (AC IN N)…...White supply wireWhite receiver wire (TO MOTOR N)..White fan wireBlack receiver wire (TO MOTOR L)…Black fan wireBlue receiver wire (FOR LIGHT)……..Blue light wireIf other fan or supply wires are different color, have this unitinstalled by qualified licensed electrician.e. Push all connected wires up into junction box.f. Lay the black antenna wire on top of the receiver, and put thereceiver in the mounting bracket. (Fig. 4)g. Reinstall all canopy on the mounting bracketh. Restore electrical power.3. OPERATING TRANSMITTER:A. Install 9 volt battery (not included) (To prevent damage to transmitterremove the battery if not use for long periods). (Fig. 5)B. Store the transmitter away from excess heat or humidity.C. This remote control unit is equipped with 16 code combinations. Toprevent possible interference from or to other remote units such asgarage door openers. Car alarm or security system. If you find that yourfan and light kit go on and off without using your remote control.Simply change the combination code in your transmitter and receiver.RECEIVERAC SUPPLYBLACKWHITEBARE GREENWHITEWHITEBLUE BLUEBLACKBLACKRECEIVERNOTE:When installing the remote control, be sure your fan is operated in "HIGH SPEED" and light is in "ON" condition at the switch knob.Fig. 1Fig. 3Fig. 4Fig. 5Fig. 2TRANSMITTERCODE SWITCHES RECEIVERONLIGHTHI OFFMED LOW9V BAT.

/ 2

Related manuals for HAMPTON BAY 191-707