－14－5) After completion of 1) - 4), pull out Clutch AdjustingPin. Hang Single-ended Wrench 36mm on the MainShaft and then stick the main shaft by a handle of thewrench touching the pole. Make sure that the mainshaft is locked. Turn the motor switch on for just amoment and make sure that the clutch is slippingwithout motor locking. WARNINGBe careful for the position of Single-ended Wrench 36mm touching on pole.(See the drawing)6) After making sure the clutch is slipping, install Hex. Plug 1/8” back into the hole.4.Checking of attaching screws◎ Check every attaching screws for loosening periodically. If found loose, tighten it.

Safety Notice for Electric Tools

Notes for Usage of Core Drill

DESCRIPTION

SPECIFICATIONS

GENERAL DRAWING AND SPECIFICATIONS IN OPERATION

Anchoring Core Drill by Anchor Bolt

Regular Servicing

FOR REPAIRING

CE DECLARATION OF CONFORMITY

HAKKEN SPZ-252U2i Instruction Manual

SPF-181Uh2i

SPM-302U2e

SPM-302U2W

SPZ-252U2i

HAKKEN SPZ-252U2i Instruction Manual

Product

Learn More

Legal