H3C WA4320i-ACN Installation Manual

Contents

H3C WA4320i-ACN Installation Manual Manual pdf 19 page image

13Connecting the AP to the networkConnect the Ethernet port of the AP to an Ethernet port of an Ethernet switch for Internet or MAN access.Verifying network connection for the fit APAll settings of the fit AP are configured on the AC. Use the display wlan ap all command on the AC thatconnects to the fit AP. If the AP status is R/M, the AP is connected to the network. display wlan ap allTotal Number of APs configured : 1Total Number of configured APs connected : 1Total Number of auto APs connected : 0AP ProfilesState : I = Idle, J = Join, JA = JoinAck, IL = ImageLoadC = Config, R = Run, KU = KeyUpdate, KC = KeyCfm--------------------------------------------------------------------------------AP Name State Model Serial-ID--------------------------------------------------------------------------------ap1 R/M WA4320i-ACN 210235A1GQB139000435-------------------------------------------------------------------------------Verifying network connection for the fat APUse the ping command on the fat AP to ping the uplink network device. If the ping operation succeeds,the AP is connected to the network successfully.