8-10To do... Use the command... RemarksAssociate MAC addresseswith a VLANmac-vlan mac-addressmac-address [ mask mac-mask ]vlan vlan-id [ priority priority ]RequiredEnter interface view interface interface-typeinterface-number Required.Configure the link type ofthe port as hybrid port link-type hybrid RequiredAssign the current hybridport to the specifiedMAC-based VLANsport hybrid vlan vlan-id-list { tagged| untagged }RequiredBy default, a hybrid port only permitspackets of VLAN 1 to pass through.Enable MAC-based VLAN mac-vlan enable RequiredDisabled by defaultDisplaying and Maintaining VLANTo do... Use the command… RemarksDisplay VLAN information display vlan [ vlan-id1 [ to vlan-id2 ] | all |dynamic | reserved | static ] Available in any viewDisplay VLAN interface information display interface vlan-interface[ vlan-interface-id ] Available in any viewDisplay MAC address-to-VLANentriesdisplay mac-vlan { all | dynamic |mac-address mac-address [ maskmac-mask ] | static | vlan vlan-id }Available in any viewDisplay all interfaces with MAC-basedVLAN enabled display mac-vlan interface Available in any viewDisplay hybrid or trunk ports on theAP display port { hybrid | trunk } Available in any viewClear statistics on a port reset counters interface [ interface-type[ interface-number ] ] Available in user viewYou can use the reset counters interface command to clear statistics on a VLAN interface. For moreinformation, see Ethernet Interface in the Layer 2 – LAN Switching Command Reference.VLAN Configuration ExampleNetwork requirementsAs shown in Figure 8-4:z AP connects to Device B through a trunk port Ethernet 1/0/1;z The default VLAN ID of Ethernet 1/0/1 is 100;z Ethernet 1/0/1 allows packets from VLAN 2, VLAN 6 through VLAN 50, and VLAN 100 to passthrough.