ADAC Ultra2 S466 Hardware Guide54Installation StepsADAC Ultra2 S466 provides extensive customizationoptions. If you need only basic ADAC Ultra2 S466features and your computer does not use other adaptercards with resource settings that may conflict with ADACUltra2 S466 settings, even custom installation can be quickand easy.Step Action Additional Information1 Unpack the ADAC Ultra2 S466 controllerand inspect for damage. Make sure allitems are in the package.If damaged, call yourGateway OEM supportrepresentative.2 Turn the computer off and remove thecover.3 Make sure the motherboard jumper settingsare correct.4 Install cache memory on the ADAC Ultra2S466 card.4 MB minimum cachememory is required.5 Check the jumper settings on the ADACUltra2 S466 controller.See page 57 for the ADACUltra2 S466 jumpersettings.6 Set SCSI termination.7 Install the ADAC Ultra2 S466 card.8 Connect the SCSI cables to SCSI devices.9 Set the target IDs for the SCSI devices.10 Replace the computer cover and turn thepower on.Be sure the SCSI devicesare powered up before or atthe same time as the hostcomputer.11 Run ADAC BIOS Setup. Optional.12 Install software drivers for the desiredoperating systems.Each step is described in detail below.Cont’d
