Garmin StreetPilot III Owner's Manual & Reference

Also see for StreetPilot III: Owner's manual Quick reference guide Specification Quick start guide Owner's manual and reference guide

Contents

Garmin StreetPilot III Owner's Manual & Reference Manual pdf 28 page image

26Marking Your Location as a WaypointIt is useful to mark a location, so that you can drive to it again later. These locations are called‘Waypoints’. The StreetPilot III can hold up to 500 Waypoints.To mark your location as a Waypoint:1. Press and hold ENTER. The ‘Waypoint Marked’ page appears, with a default three-digit name for thenew Waypoint in the upper-left portion of the page. The StreetPilot III captures the location from theinstant at which you pressed ENTER, so you do not need to be concerned about moving around orlosing satellite reception, your Waypoint is safely stored.To rename the Waypoint:1. Use the ROCKER KEYPAD to select the name and press ENTER.2. Enter the new waypoint name using the ROCKER KEYPAD, and press ENTER.Each waypoint may also be assigned a custom waypoint symbol for easy recognition on the Mappage.To change the Waypoint symbol:1. Highlight the Waypoint symbol field (immediately to the left of the waypoint name) and pressENTER. Use the ROCKER KEYPAD to select the desired symbol.2. Press ENTER when you find the most appropriate symbol. The new Waypoint is now stored inmemory.At the bottom of the Waypoint Marked page there are three option buttons that may be selected:Delete – deletes the waypoint.Show Map – Shows the waypoint on the Map page.Route To It – Tells the unit that you want to navigate to that waypoint.ReferenceMarking WaypointsA waypoint is stored in memory as soon as the ‘WaypointMarked’ page appears.There are approximately 50 waypoint symbols to choosefrom. These symbols are used to mark the waypoint’sposition on the Map page.