Garmin GTM 11 Owner's Manual

Also see for GTM 11: Owner's manual Declaration of conformity

Contents

Garmin GTM 11 Owner's Manual Manual pdf 6 page image

ENEN-4 GTM 11 Owner’s ManualTo mount the GTM 11 with the hook-and-loop fastener:1. Clean and dry a section of the A-pillar or other suitable mountingsurface.2. Remove the backing from the back of the loop material.3. Firmly press the loop material to the mounting surface.4. Remove the backing from the back of the hook material.5. Firmly press the hook material to the back of the GTM 11.Attach the hook material here.6. Position the GTM 11 so the antenna is pointing up, and attach thehook material on the GTM 11 to the loop material on the mountingsurface.Routing the CableRoute the GTM 11 cable so that it does not interfere with vehicle operatingcontrols. If the cable is not long enough, a 2-meter extension cable isavailable from your Garmin dealer or at www.garmin.com/products/gtm11.Notes about the Hook-and-LoopIf you use the hook-and-loop fastener to attach your GTM 11 to the A-pillar, you can also install a strip of loop material on the A-pillar of anothervehicle. This allows your GTM 11 to be completely portable.Notes about the Wire AntennaUse the wire antenna instead of the whip antenna if either of the followingis true:• The whip antenna does not get an adequate signal strength.• You wish to hide the GTM 11, perhaps in the glove compartment orunder the dash.If you use the wire antenna, you should route the wire along the A-pillarand around the windscreen. The wire can be tucked under the plastic of theA-pillar and under the head-liner to hide it. The GTM 11 can also be hiddenfrom view when the wire antenna is used.If necessary, shorten the wire antenna by cutting the excess wire usingscissors.