Garmin Fusion Wireless RGB LED Remote Control Instructions Manual

Garmin Fusion Wireless RGB LED Remote Control Instructions Manual Manual pdf 1 page image

Wireless RGB LED Remote Control InstructionsImportant Safety InformationWARNINGFailure to follow these warnings and cautions could result in personal injury, damage to the vessel, or poorproduct performance.See the Important Safety and Product Information guide in the stereo box for product warnings and otherimportant information.This device must be installed according to these instructions.Disconnect the vessel's power supply before beginning to install this product.CAUTIONAlways wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.NOTICEWhen drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.You must read all installation instructions before beginning the installation. If you experience difficulty duringthe installation, contact Fusion®Product Support.What's in the Box?• Wireless RGB LED remote control• Remote control receiver• Remote control cradle• 7.5 A in-line fuse• Important safety and product information documentSupplies and Tools Needed• 2-conductor 22 AWG (0.33 mm2) wire to connect the remote control receiver to the power source• 4-conductor 22 AWG (0.33 mm2) wire (or equivalent combination of 2-conductor wire) to connect thereceiver to the RGB LED speakers• Cable ties or adhesive for mounting the receiver• 4 gauge (3 mm) countersunk stainless-steel screws for mounting the remote cradle (optional)• 3 mm flat screwdriver• Wire cutters• Drill and drill bits for mounting the remote cradle (optional)GUID-EE2CF989-3621-4468-952F-F2FF10257458 v2July 2021