Garmin Fishfinder 160C Owner's Manual

Also see for Fishfinder 160C: Owner's manual Owner's manual Declaration of conformity Specification

Garmin Fishfinder 160C Owner's Manual Manual pdf 10 page image

6 Fishfinder 160C Owner’s ManualINSTALLATION INSTRUCTIONS > TRANSDUCER INSTALLATIONMounting the Transducer on a Trolling MotorTo mount the transducer on a trolling motor:1. Slide the large cable tie through the slot on the transducermount with the ridges of the band facing up until equallengths extend on both sides of the mount. (NOTE: For coldwater, or heavy timber or debris areas, a metal 4-5" wormgear clamp is recommended.)2. Position the mount gasket on the curved top of the transducermount.3. Place the transducer assembly against the motor body of thetrolling motor, with the front of the transducer pointed awayfrom the trolling motor propeller.4. Wrap the two ends of the cable tie around the motor body.Place the pointed end of the cable tie through the fastenerhole on the opposite end and pull it through until it is snug butnot tight. (The cable tie clicks when you pull it.)5. Position the transducer so that it is parallel with the bottomwhen in use, and make sure the gasket is aligned properly.Pull the cable tie end until tight. Trim off the excess, ifnecessary. Tighten the 10-32 locking nut until it touches themounting bracket and then tighten 1/4 turn more. (Do notovertighten.)6. Route the 30' (9 m) transducer cable using the supplied cableties to secure the cable to the motor shaft. You can fill theforward-facing portion (except the cable tie pocket) of thetransducer mount with sealant to avoid accumulating debris.Cable tieMountinggasket